SWINfan Posted February 9, 2017 Share Posted February 9, 2017 I'm old school and like to print out brackets at home. Any suggestions on how to do so from Track so they fit on one page but take up most of the page? I've been playing with the width, height and Font size, and haven't had much luck. Link to comment Share on other sites More sharing options...
warsawwrestling Posted February 9, 2017 Share Posted February 9, 2017 I think if you go through weights to bracket it prints on 1 sheet. A longer process but believe it will put it all on one sheet. Link to comment Share on other sites More sharing options...
supercharger1208 Posted February 9, 2017 Share Posted February 9, 2017 i miss the special "indiana mat gorilla" brackets. i say we bring them back Link to comment Share on other sites More sharing options...
Y2CJ41 Posted February 9, 2017 Share Posted February 9, 2017 i miss the special "indiana mat gorilla" brackets. i say we bring them back They will be out for state supercharger1208 1 Link to comment Share on other sites More sharing options...
SWINfan Posted February 9, 2017 Author Share Posted February 9, 2017 (edited) I think if you go through weights to bracket it prints on 1 sheet. A longer process but believe it will put it all on one sheet. They are the same as just going directly to the brackets. The problem is the whole bracket takes up less than half the page leaving the lines small and way to much white space. But they do fit to one page. Edited February 9, 2017 by SWINfan Link to comment Share on other sites More sharing options...
TripleB Posted February 9, 2017 Share Posted February 9, 2017 Switch your printer to landscape, boom Link to comment Share on other sites More sharing options...
SWINfan Posted February 9, 2017 Author Share Posted February 9, 2017 Switch your printer to landscape, boom I did, it only stretches halfway across the page and barely more than half to the bottom. Link to comment Share on other sites More sharing options...
pm1981 Posted February 9, 2017 Share Posted February 9, 2017 I had trouble also. When I went to print I found that it was on shrink to fit screen. I clicked on 100% and then it took up the entire page landscape style. I finally got it to work. Link to comment Share on other sites More sharing options...
warsawwrestling Posted February 9, 2017 Share Posted February 9, 2017 I find buying them at event much easier. Lol. Link to comment Share on other sites More sharing options...
navy80 Posted February 9, 2017 Share Posted February 9, 2017 Snip it and paste it to a word document. Takes a few minutes but gets the job done and you can size the brackets however big or small you want. Link to comment Share on other sites More sharing options...
Recommended Posts